IEI Technology WAFER-LX, User Manual

Page: 8 / 144

WAFER-LX
Figure 2-20 CN27 IrDA Interface Port ....................................................................25
Figure 2-21 CN28 TFT Panel Display Connector...................................................26
Figure 2-22 CN29 LVDS Panel Display Connector ................................................27
Figure 2-23 IDE Connector.....................................................................................28
Figure 2-24 CN31 Floppy Port................................................................................29
Figure 2-25 Front Panel Connectors ......................................................................31
Figure 2-26 10/100BaseT Ethernet (RJ-45) Port....................................................31
Safety Notice
Electrical shock hazards might occur while proceeding with the installation, repair and
maintenance of this product. Therefore, the following precaution measures should be carefully
observed:
1. All sorts of operations on this product must be carried out by certified technicians.
2. The chassis into which the embedded board and its associated backplane are installed
should provide stable power supply and be properly grounded.
3. Power off the embedded board and unplug its power cord before handling.
4. When handling the embedded board, avoid touching any metal leads or connectors.
5.
Please verify that the power supply is switched off before unplugging the power supply
connector from the embedded board.
ESD Precautions
Observe all conventional anti-ESD methods while handling the embedded board.
The use of a grounded wrist strap and an anti-static work pad is recommended.
Avoid dust and debris or other static-accumulating materials in your work area.
Page 8
Page 8
IEI
®
Technology, Corp.