IEI Technology IMB-8550, User Manual

Page: 79 / 166

IMB-8550
DIMM Installation
The IMB-8550 provides two (2) DIMM sockets for a maximum total memory module up to 2GB
DDR SDRAM.
To install memory module, first make sure the two white clips on the DIMM socket are in the “open”
position (the handles lean outward).
Verify the orientation of the module by checking the notch on the memory module. Slowly slide
the DIMM module along the plastic guide on both ends of the socket, then press the DIMM module
down into the socket, until you hear a “click” sound. This is when the two clips have automatically
locked the module into the correct position of the DIMM socket. To remove the DIMM module,
push both handles outward, and the memory module should be ejected by the mechanism in the
socket.
Connections to the Peripherals
IEI provides the following cables to facilitate connections to your peripheral devices. For more
information on the locations of the connectors, please refer to Chapter 2 . Cables not included in
kit are user supplied items and should be separately purchased.
No. Type
2 ATA 66/100 flat cable
2 SATA cables
1 SATA power cable
3 RS-232 cable (2 x 2 kit; 1 x 1 kit)
1 Rear panel I/O bracket
Table 3 - 6 Cables Included in Kit
3-17
3-17