IDTECK Star 100R, User Manual

Page: 28 / 40

28
● Problem
The 100R operates suddenly on general mode during setting or registering a user on mode
selection.
● Cause
▶
Over standby time on mode selection
● Solution
▶
If not entering a key or a card within 20 sec. on mode selection, the product operates on
general mode automatically.
[Registering or Deletion]
● Problem
User Card or PIN cannot be registered additionally.
● Cause
▶
An error in using a product or in system settings
▶
Over permissible register person
● Solution
▶
Make sure that installation and operation are normal.
☞
When installing the 100R first or When finishing system initialization
#1)
.
Because system is the status of initialization, register mode selection, master card
(or PIN) and user.
1. 100R Mode Selection: Mode ENT
RF Only 01 + ENT
RF + P/W 02 + ENT
PIN Only 03 + ENT
RF or PIN 05 + ENT
2. Enter the master card (or PIN: 4 to 6digit (mode 03 or 05) + ENT).
3. By modes, enter the master card, PIN and password.
4. Enter the master card (or PIN: 4 to 6digit (mode 03 or 05) + ENT).
☞
When registering a user card additionally while using a product.
Register a user card only because master card is registered.
1. Enter the master card (or PIN: 4 to 6digit (mode 03 or 05) + ENT).
2. By modes, enter “Mode ENT” to add user access cards.
RF Only 11 + ENT
RF + P/W 12 + ENT
PIN Only 13 + ENT
RF or PIN 15 + ENT
3. By modes, enter a user card, PIN and password.
4. Enter the master card (or PIN: 4 to 6digit (mode 03 or 05) + ENT).
● If the problem still persists, contact our customer service center.
#1)
System Initialization: See page 24 of this manual.
#2)
Initial Setting: See page 10 of this manual.
See “Initial Setting
#2)
” to register master or user.
Caution
See “Initial Setting
#2)
” to register master or user. Caution