IDTECK Star 100R, User Manual

Page: 30 / 40

30
● Problem
Registering/deleting a card and setting change cannot be used because of loosing a master
card or PIN.
● Cause
▶
A user carelessness
● Solution
▶
When loosing a master card or PIN, if you change product’s settings, you should initialize
the product.
☞
In system initialization, master, user and system settings are changed by initials.
☞
System Initialization by product’s versions
- 100R V5.0.0 under or IP100R V2.0.0 under
1. After power is off, separate product from wall.
2. Separate enclosure slicing four screws off the rear of product.
3. Turn on product as step 2 stands.
For initializing, connect jumper switches which are located by LEDs bottom of PCB.
4. Make sure of system initialization.
At this time, 3 LEDs should be blinked simultaneously.
5. After power is off, assemble the rear of product fixing four screws.
Finishing assembly, fix the product all right again on wall.
- 100R V5.0.0 over or IP100R V2.0.0 over
1. After power is off, separate product from wall.
2. Connect orange wire to orange with white stripe wire.
3. After power is on, make sure of system initialization
#1)
.
At this time, bell grows in sound and LEDs blink.
4. After slicing two short wires off the product, make off the power.
5. Use it installing the product all right again.
#1)
#1)
System Initialization: See page 24 of this Manual.
See “System Initialization
#1)
” to register master or user. Caution