10
5. Setting up the device
Menu level
Parameterisation level
Setting of the pulse delay,
dELAY:
Default:
0
With the pulse delay of 0–250 seconds (max), frequencies can be collected, which are even
smaller than by the predetermined measuring time of the device. If e.g. a delay of 250 seconds
is set, it means that the device waits up to 250 seconds for an edge, before it assumes a 0 Hz
frequency. Thus frequencies up to 0.004 Hz can be collected.
Adjustment of the optimum digital frequency filter,
fi.frq:
Default:
NO
If the optional filter is not activated by the adjustment „
No
“, frequences are ignored by the
adjusted frequency filter. Act on the assumption that the pulse-duty factor is 1:1. Accordingly
the minimal pulse duration is derived from the half of the time of oscillation. Use a filter of 10 Hz
or 20 Hz for contact bounce suppression.
Setting up the final value of the bargraph,
ba.ENd:
Default:
1000
Set the final value from the smallest to the highest digit with [
▲
] [
▼
] and confirm each digit
with
[P]
. A minus sign can only be parameterized on the highest value digit. After the last digit,
the display switches back to the menu level.
Setting up the initial value of the bargraph,
baoff:
Default:
O
Set the initial value from the smallest to the highest digit with [
▲
] [
▼
] and confirm each digit
with
[P]
. A minus sign can only be parameterized on the highest value digit. After the last digit,
the display switches back to the menu level.
Selection of the bargraph functions,
ba.fct:
Default:
bar.fo
The bargraph can be displayed with the following possibilites: bars from left to right (top to
bottom) or bars from right to left (bottom to top), bars from the middle, a dot display of the
bargraph or a dot display with a permanently displayed midpoint. Confirm the selection by
pressing the
[P]
button. The display then switches back to the menu level again.