17
5. Setting up the device
Menu level
Parameterisation level
Display values for setpoints,
dIS.01 … dIS.30:
Under this parameter setpoints are defined according to their value. At the sensor calibration,
like at final value/offset, one is asked at the end if a calibration shall be activated.
Analog values for setpoints,
InP.01 … InP.30:
These setpoints are displayed at works setting (4-20 mA) only. Here, demanded analog values
can be choosen freely. The input of steadily rising analog values needs to be done self-
contained.
Display underflow,
dI.Und:
Default:
-19999
With this function the device undercut (
_ _ _ _ _
) can be defined on a definite value. Exception is
input type
4-20 mA
, it already shows undercut at a signal <1 mA, so a sensor failure is marked.
Display overflow,
dI.OUE:
Default:
99999
With this function the display overflow (
_ _ _ _ _
) can be defined on a definite value.
Input variable of process value,
SIG.in
:
Default:
a.meas
With this parameter the device can be controlled via the analog input signals
a.meas
=
Sens.f
/
fre9u
or via the digital signals of the interface
M.bus
= RS232/RS485 (modbus protocol). With
[P]
the selection is confirmed and the device changes into menu level.
Back to menu group level,
rEt:
With
[P]
the selection is confirmed and the device changes into menu group level
„–INP–“
.
