7
2
BIIS 1200 OPERATION
D
Direct code entry
q
In the standby mode, push
[TX Code Enter]
to enter the
TX code edit mode.
• A Code digit blinks.
1 2 3 4
w
Push
[TX Code Enter]
to select the desired digit to be
edited.
• Editable digits differ according to the transceiver setting.
e
Push
[CH Up]
or
[CH Down]
to select the desired digit.
r
Push
[TX Code Enter]
to set the digit, then the digit to the
right will automatically blink.
t
Repeat
e
and
r
to edit all allowable digits.
y
Push
[Call]
or
[PTT]
* to call.
* A PTT call can be made only when PTT call capability is permit-
ted.
NOTE:
When no answer back is received, the trans-
ceiver automatically repeats the call 3 times (default),
and “
WAIT
” is displayed during each call. However, an
error beep sounds and “
FAILED
” is displayed when
no answer back is received after the repeated calls.
u
Push
[PTT]
to transmit; release to receive.
i
Push
[Moni (Audi)]
to send a ‘Clear down’ signal.
For your information
When the “UpDate” setting for the call code is enabled, the
set code is overwritten into the call code memory.
