Icom IC-E2820, Instruction Manual

Page: 70 / 164

49
5
DV MODE OPERATION (Optional UT-123 is required)
■
Copying the call sign
D D
Copying the call sign memory contents
This function is convenient when modifying part of the current
call sign.
NOTE:
Make sure that the “EDIT RECORD” item in DV set
mode is set to “AUTO” in advance.
(p. 102)
q
Push
[
F
• ]
twice to display the function guide 2.
w
Push
[CS](V/MHz•SCAN)
(Left band’s)
to display the “CALL
SIGN” screen.
e
Rotate
[DIAL]
to select “YOUR” or “RPT1/2” then push
[MAIN•BAND
].
r
Rotate
[DIAL]
to select the desired call sign channel.
• U01–U60 and R01–R60 are available.
t
Push
[MAIN•BAND]
.
• The selected call sign channel contents are copied into a blank
channel automatically and call sign programming mode is se-
lected.
y
Edit or modify the copied call sign as follows;
• Push [<](V/MHz•SCAN) (Left band’s) [>](M/CALL•MW) (Left
band’s) or to move the cursor left or right, respectively.
• Push [ABC](TONE•DTMF) to select the character group from
capital letter characters.
• Push [12/](M/CALL•MW) (Right band’s) to select the character
group from numbers or symbols.
• Push [CLR](DUP•MONI) to clear the selected character.
• Push [GW](LOW•PRIO) to turn the gateway setting ON/OFF.
(available only when “RPT1/2” is selected in step
e
)
u
Push [BACK](V/MHz•SCAN)
(Right band’s)
to store the
edited/modi fi ed call sign into the selected blank channel,
or push [MAIN•BAND] to store the call sign into the chan-
nel and set for the call.
NOTE:
The message “FULL” is displayed when no blank channel
is available in the station or repeater call sign memory.