Icom IC-E2820, Instruction Manual

Page: 60 / 164

39
5
DV MODE OPERATION (Optional UT-123 is required)
D D
When calling the desired station
Continued instruction from step
v
on page 38.
b
Rotate
[DIAL]
to select “YOUR,” then push
[MAIN•BAND]
.
• YOUR CALL SIGN screen is displayed.
n
Rotate [DIAL] to select the call sign channel in which de-
sired station’s call sign is programmed.
• See page 38 for station call sign programming details.
m
Push
[BACK](V/MHz•SCAN) (Right band’s)
to set the sta-
tion’s call sign and return to CALL SIGN screen.
,
Push
[BACK](V/MHz•SCAN) (Right band’s)
again to return
to function guide 2 indication.
.
Perform the instruction steps
t
to
y
on page 38.
D D
When sending a CQ
Continued instruction from step
v
on page 38.
b
Push
[CQ](DUP•MONI)
to set “CQCQCQ” as the call sign.
n
Push
[BACK](V/MHz•SCAN) (Right band’s)
to return to
function guide 2 indication.
m
Perform the instruction step
t
to
y
on page 38.
✔
For your information!
Your own
(MY)
call sign, Station call sign and repeater call
sign can also be programmed/edited in “CALL SIGN” screen.
In addition, when editing a call sign stored in a call sign mem-
ory, regular memory or call channel, the default operation is to
over-write a programmed call sign in regular memory and call
channels.
(Temporary operation without over-writing is possible.)
However, the edited call sign can store into a blank channel
automatically when “AUTO” is set with the EDIT RECORD
(p. 102)
.
z
While displaying “CALL SIGN” screen, rotate [DIAL] to select
either “YOUR,” “RPT1/2” or “MY” then push
[MAIN•BAND]
.
x
Rotate [DIAL] to select the desired call sign memory chan-
nel then push
[MAIN•BAND]
.
c
Rotate [DIAL] to select the desired call sign memory chan-
nel then push
[MAIN•BAND]
.
v
Rotate [DIAL] to select the desired character.
• Push [ABC](TONE•DTMF) to select the character group from
capital letter characters.
• Push [12/](M/CALL•MW) (Right band’s) to select the character
group from numbers or symbol.
• Push [>](M/CALL•MW) (Left band’s) or [<](V/MHz•SCAN) (Left
band’s) to move the cursor right or left, respectively.
• Push [CLR](DUP•MONI) to clear the selected character.
• Push [GW](LOW•PRIO) (available only when RPT1/2 is selected
in step
z
) to turn the gateway setting ON/OFF.
b
After the desired call sign
(up to 8-characters)
is entered,
push [BACK](V/MHz•SCAN)
(Right band’s)
.