IBM TS7650G PROTECTIER DEDUPLICATION GATEWAY, User Manual

Page: 211 / 248

8. Press
<Enter>
to continue. The replacement procedure will restore the
configuration files from the server's repository, and this will take several
minutes to complete.
9. If you are recovering a server in an FSI environment, and FSI was configured
for Active Directory authentication, you must run the Authentication setup
wizard
to reset the parameters for the active directory. For more information,
go to “Defining the Active directory” on page 79.
10. Once the information has been provided, proceed to “Activating ProtecTIER
Replication Manager” on page 192.
Activating, analyzing and restoring ProtecTIER Replication Manager
This section describes the procedure for activating, analyzing and restoring an
inactive or "lost" ProtecTIER Replication Manager server using ProtecTIER
Manager.
The ProtecTIER Replication Manager restore procedure is done grid by grid and
can be done in either of the following ways:
v
Using an existing backup file:
PtReplicationManager_<hostName>_<customerName>_time_ConfigurationBackup.zip
v Using an accessible repository that was once a member of a grid.
Model <TS7650_DS4700_128_450>
Option 1
**************************************************
node id : 2
hostname : pinsk
ip : 9.148.220.155
Select option: 1
Recoverable static routes configuration found, would you like to restore it?
(yes|no) yes
Recovering Static Routes [ Done ]
Configuring network
[ Done ]
Configuring Replication Network [ Done ]
Restarting Network Service [ Done ]
Stopping Remote VTFD [ Done ]
Stopping Remote RAS [ Done ]
Stopping cluster [ Done ]
Configuring cluster [ Done ]
Starting cluster [ Done ]
Installing NTP [ Done ]
Mounting file systems [ Done ]
Restoring node ID [ Done ]
Starting VTFD locally [ Done ]
Starting RAS [ Done ]
Starting VTFD remotely [ Done ]
Starting RAS remotely [ Done ]
Checking RAS Configuration [ Done ]
Restoring RAS Configuration [ Done ]
Collecting RAS Persistent configuration [ Done ]
Running RAS Eth Agent [ Done ]
validation will start in 10 seconds
Testing customer network connectivity
[ Done ]
Testing connectivity to the Default Gateway [ Done ]
Getting number of nodes [ Done ]
Testing NTP configuration [ Done ]
Testing cluster’s network speed [ Done ]
replace ended successfully
End Processing Procedure Successfully
Press <ENTER> to continue
Chapter 18. ProtecTIER system recovery procedures
191