IBM System Storage TS7600 ProtecTIER Series, Software Upgrade Manual

Page: 75 / 132

Appendix D. IP address worksheet
Use this worksheet to specify the IP addresses assigned to the TS7650G or TS7650
Appliance components. IBM service representatives use the information provided
to define the IP addresses of components supported by the TSSC. When the TSSC
sends Call Home information to IBM through VPN or modem, or sends you
notices about serviceable events, these settings will be included in the information
to identify and provide important information about the TSSC that sent a service
request.
Table 6 on page 62 and Table 8 on page 63 show the default IP addresses for the
TS7650G and TS7650 Appliance servers with VTL configurations.
Table 7 on page 62 and Table 9 on page 64 show the default IP addresses for the
TS7650G and TS7650 Appliance servers with OpenStorage configurations.
Table 11 on page 66 shows the IP address, network mask, DNS and VLAN settings
for the source and destination servers for replication. This information is needed to
configure the individual ports to communicate and transfer data over the
replication network. Write this information in the spaces provided for future
reference. Table 12 on page 67 shows the host names and other settings needed for
replication. Write the appropriate information in the spaces provided for future
reference.
Table 13 on page 69 shows the default IP addresses for the TSSC.
Table 14 on page 69 shows the IP address ranges for the gateway or appliance
components once they are configured to be on the TSSC's 172.31.1.xx network. In
the spaces provided in Table 14 on page 69, write the IP addresses that you assign
for each component, so that the IP address information is available for future
reference.
© Copyright IBM Corp. 2011
61