IBM System Storage TS7600 ProtecTIER Series, Software Upgrade Manual

Page: 100 / 132

12. In the Login window, enter
USERID
as the username and
PASSW0RD
(with a
zero) as the password, and then click OK .
Note: The username and password are case sensitive and must be entered in
all uppercase.
The
Remote Supervisor Adapter II Refresh 1 Welcome window opens.
13. In the Remote Supervisor Adapter II Refresh 1 Welcome window:
a. Use the Inactive session timeout value dropdown list to specify a
reasonable amount of time which will keep your session active until you
can complete your task. (Ten minutes should suffice.)
Do not select the
No Timeout
setting, as this will prevent anyone else
from logging into the RSA until you have logged out.
b. Click Continue . See Figure 9.
You are now logged into the server's RSA.
c.
Do one of the following, as appropriate:
v
If you are altering the default IP address of the RSA on Server B to
avoid an IP address conflict, continue with step 14.
v
If you are connecting to the RSA to establish a command line interface
to a stand-alone server, or either server in a cluster, skip the remaining
steps in this procedure and go to “Enabling Remote Control” on page
87.
14. In the ASM section of the left-side navigation pane of the Remote Supervisor
Adapter II Refresh 1 Welcome window, click Network Interface .
15. In the Static IP Address field, change the last octet to an address value that is
lower than the default of 254.
For example: 172.31.1.253 .
16. In the Netmask field, enter:
255.255.255.0
.
17.
Leave the
Gateway
field blank.
18. Click Save .
ts760200
Figure 9. Remote Supervisor Adapter II Refresh 1 Welcome window
86
IBM System Storage TS7600 with ProtecTIER: Software Upgrade Guide