IBM System Cluster 1350, Installation And Service

Page: 133 / 170

4. Mount the Power Management Module tray into the cabinet in Slot 18.
a. Slide the tray into the cabinet from the rear of the cabinet, as shown in
Figure 22. Slide the tray partially in and route the remote power cables
(which go to the RSA cards in the Nodes) and the cable to the PDU out
through the cable management slot in the tray.
If the tray catches as you are sliding it into the cabinet, push up on the tray
from underneath.
b. Insert the mounting screws into the rear vertical cabinet rails, as shown in
Figure 22. Do not tighten the screws.
Figure 22. Install Power Management Module tray into cabinet from the rear of the cabinet, part 1
Chapter 20. Power Management Module replacement and configuration
115