IBM System Cluster 1350, Installation And Service

Page: 116 / 170

b.
Slide the switch rails into the cabinet from the rear of the cabinet, as shown
in Figure 15. Slide the rails part way in and route the power cables and
Ethernet cables from the front of the cabinet. Route the cable through the
Cable Management Tab shown in Figure 14 on page 97.
c. Insert the mounting screws in the rear vertical cabinet rails, as shown in
Figure 15. Insert two screws on each side. Do not tighten the screws.
If you have difficulty with neighboring mounting screws of components
already installed, loosen these mounting screws then tighten once all of the
component rails are installed.
Figure 15. Install switch rails into cabinet from the rear of the cabinet
98
Installation and Service