IBM System Cluster 1350, Installation And Service

Page: 123 / 170

Setup troubleshooting
Once the initial setup is complete, there should be a network connection between
the PC and the switch. If a ping to the switch fails, verify the IP address and
gateway to ensure the subnet and gateway addresses match:
v
On the PC use the command: ipconfig
v
On the switch use the command: show running
Nodes on the same VLAN can communicate via ping/telnet. They cannot
communicate to nodes on different VLANs. To verify VLANs:
v
Connect node1 and node2 to the same VLAN and ping node2 from node1. It
should succeed.
v
Connect node1 to VLAN1 and node2 to VLAN2 and ping node2 from node1. It
should fail.
Additional information
Catalyst 5000 Family Ethernet and Fast Ethernet Switching Modules Installation and Configuration Note
(including Translated Safety warnings 10 languages):
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/cnfg_nts/ethernet/5014etsm.htm#20508
Catalyst 3500 Series XL Hardware Installation Guide Includes Troubleshooting:
http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35wc/3500ig/index.htm
Catalyst 2900 Series XL and 3500 Series XL Cisco IOS Release 12.0(5.3)XU:
http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35wc/rn53/1061505.htm
Quick Start Guide Catalyst 3500 Series XL Switches:
http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35xu/3500.htm
Chapter 17. Cisco Gigabit Switch replacement and configuration
105