IBM ServeRAID, User Reference

Page: 89 / 226

4. Copy IPSSEND to your hard disk. From the DOS prompt, type the following and
press Enter:
copy e :\netware\cmdline\ipssend.nlm c :\ nwserver
where e is the drive letter of the CD-ROM drive that contains the IBM
ServeRAID Support CD, c is the drive letter of the drive where NetWare is
installed, and nwserver is the directory where NetWare is installed.
5. Remove the IBM ServeRAID Support CD from the CD-ROM drive.
6. From the DOS prompt, ensure that you are in the c :\ nwserver directory; then,
type the following and press Enter to restart NetWare:
server
Installing IPSSEND for NetWare from diskette
Complete the following steps to install IPSSEND for NetWare using the IBM
ServeRAID Support for NetWare diskette:
1. Start the server.
2. Exit to DOS. From the console prompt, type the following and press Enter:
down
3. Insert the IBM ServeRAID Support for NetWare diskette into the diskette drive.
4. Copy IPSSEND to your hard disk. From the DOS prompt, type the following and
press Enter:
copy a :\cmdline\ipssend.nlm c :\ nwserver
where a is the drive letter of the diskette drive that contains the IBM ServeRAID
Support for NetWare diskette, c is the drive letter of the drive where NetWare is
installed, and nwserver is the directory where NetWare is installed.
5. Remove the IBM ServeRAID Support for NetWare diskette from the diskette
drive.
6. From the DOS prompt, ensure that you are in the c :\ nwserver directory; then,
type the following and press Enter to restart NetWare:
server
Installing IPSSEND for Linux
You can install this program for Red Hat Linux, SuSE Linux, Caldera OpenLinux, or
Turbolinux using either the
IBM ServeRAID Support CD or the appropriate IBM
ServeRAID Suppor t diskette.
Note: For IPSSEND to work properly under Linux, the following conditions must
apply:
v
You must have SCSI Generic support compiled into your kernel. See the
Linux Kernel-HOWTO for more information on configuring and recompiling
your kernel.
v You must have permission to access the SCSI Generic device files in
/dev.
Installing IPSSEND for Linux from CD
Complete the following steps to install IPSSEND for Linux using the IBM
ServeRAID Support CD:
1. Start the server.
2. After the operating system starts, insert the IBM ServeRAID Support CD into the
CD-ROM drive.
Chapter 8. Installing and using the IPSSEND command-line program
73