IBM ServeRAID, User Reference

Page: 167 / 226

ISPR register codes
Code Explanation Action
1xxx to
7xxx The POST detected an internal error. Contact your IBM service representative.
2601 to
260B The POST detected an error with the ServeRAID
subsystem. Contact your IBM service representative.
2610 The POST detected an error with the ServeRAID
controller hardware. Contact your IBM service representative.
2620 The POST detected that a ServeRAID
configuration or hard disk error occurred. Start the IBM ServeRAID Support CD and view the
existing device and configuration information for
your ServeRAID subsystem. If you cannot locate
and correct the configuration problem or the failing
device, or if the problem persists, contact your IBM
service representative.
3E20H The POST detected that the ServeRAID-5i
controller is in the wrong PCI expansion slot. Install the ServeRAID-5i controller in the correct
PCI expansion slot. See the documentation that
came with your server for more information.
3E2xH The POST detected an error. Contact your IBM service representative.
8xxx to
Bxxx The POST detected an error with the SCSI
interface. Verify that the SCSI cables are correctly connected
and the SCSI termination is set properly for each
installed SCSI device.
If you cannot locate and correct the SCSI problem,
or if the problem persists, contact your IBM service
representative.
BCS and ECS register codes
Notes:
1. When the ServeRAID controller requires your input, a list of function keys will be
displayed below the message.
2. Where the Action information tells you to start the IBM ServeRAID configuration
program, insert the IBM ServeRAID Support CD into the CD-ROM drive; then,
restart the server. The Action column also provides general information about
the message.
BCS ECS Explanation Action
Code
not in
table Code
not in
table The ServeRAID controller is not functioning
properly. Contact your IBM service representative.
00 01 Invalid flash configuration. Start the IBM ServeRAID Support CD and follow
the instructions that appear on the screen.
If no instructions appear or if the problem persists,
contact your IBM service representative.
00 02 Invalid NVRAM configuration.
00 03 Invalid flash and NVRAM configuration.
Chapter 18. Solving ServeRAID problems
151