IBM SAN256B-6, Installation, Service And User Manual

Page: 54 / 292

Note: Screws, clip nuts, and retainer nuts for securing the device to the equipment rack are included
in the device hardware accessory kit.
1 - 10-32 x .63 in.(1.60 cm) Phillips screw with square cone washer for racks that have rails with
round holes
Note: For rails with round holes, use the clip nuts on the front rails for securing 10-32 screws. For
rails with square holes, use the retainer nuts (refer to Figure 7). Also refer to Figure 8.
6. Reinstall the device door if removed. Refer to procedures for removing and replacing the device door
in this guide.
Installing the device in a 27-31-inch rack
Use the following instructions to install the device in a rack with rail-to-rail depth of 27 to 31 in. (68.58 to
78.74 cm). Be sure to use the 27-31 in. 8U Chassis Airflow Diversion and Port Side Exhaust Kit for
Four-Post Rack for this installation.
Parts list
The following parts list refers to items illustrated in the following figure.
Note: Not all parts may be used with certain installations depending on the device type.
Table 10. Hardware for Airflow Diversion and Port Side Exhaust Kit for 27-31 in. (68.58 to 78.74 cm) racks
Description Quantity
Top rail 1
Duct 1
Figure 9. IBM device with 18-24 in. (45.72 to 60.96 cm) kit installed in rack
26
SAN256B-6 Installation, Service, and User Guide