IBM SAN256B-6, Installation, Service And User Manual

Page: 57 / 292

1 - Attaching clip nuts for round hole rails
2 - Clip or retainer nut locations for device
3 - Clip or retainer nut locations for shelf
4 - Retainer nut for rails with square holes
5 - Rail
3. Install the shelf as shown in the following figure.
a. The shelf can be adjusted to a length of between 27 and 31 inches (68.58 and 78.74 cm) to
accommodate your rack size. To lengthen or shorten the shelf, loosen the four 6-32 screws in the
four slots on the shelf (seeFigure 1) and adjust the shelf to the desired length. Once adjusted,
tighten the four 6-32 screws.
b.
Secure the shelf to the rack with eight 10-32 screws with washers, two screws in each corner of the
shelf (see the following figure). Tighten the screws according to specifications underTorque
requirements.
Figure 11. Clip and retainer nut locations on rack rails
Mounting the Device
29