IBM SAN256B-6, Installation, Service And User Manual

Page: 53 / 292

1 - Top rail
2 - Duct
3 - 6-32 x .25 in. (.635 cm) Phillips screws
4 - 10-32 x .5 in. (1.27 cm) Phillips screws with blue Loctite on threads and alignment washers
or 10-32 x .63 in.(1.60 cm) Phillips screw with square cone washer
Installing the device in the rack
Procedure
1. If a door is installed on your chassis, ensure that it is removed. Refer to procedures for removing and
replacing the device door in this guide.
2. Use a hydraulic lift to raise the device to the correct level.
18-32 kg (39.7-70.5 lbs)
svc00167
DANGER
Use safe lifting practices when moving the product.
3. If applicable, lock the wheels of the lift.
4.
Carefully lift the device and slide it into the rack.
5. Secure the device to the rack with six 10-32 screws with washers, three screws on each side (refer to
the following figure). Tighten the screws according to specifications under “Torque requirements” on
page 21.
Figure 8. Securing top rail in rack
Mounting the Device
25