IBM SAN256B-6, Installation, Service And User Manual

Page: 211 / 292

Cable management fingers
This chapter provides the following information:
v “Cable management fingers overview”
v “Time and items required for removal and replacement”
v “Removing the cable management finger assembly”
v “Installing the cable management fingers” on page 185
Cable management fingers overview
The SAN256B-6 comes equipped with two vertical cable management finger assemblies. It can continue
to operate during the replacement of the cable management fingers. Due to the horizontal orientation of
the blades in the device, the finger assemblies are attached to the uprights of the mounting rack.
Time and items required for removal and replacement
The replacement procedure for the cable management fingers takes less than five minutes. A #1 Phillips
screwdriver is required.
Removing the cable management finger assembly
About this task
Complete the following steps to remove the cable management finger assemblies from rack uprights.
Cable management finger assemblies are shown installed in the following illustration.
© Copyright IBM Corp. 2018
183