IBM Redboks System x3550 M4, Installation And User Manual

Page: 117 / 158

Note: The positioning of the remote battery depends on the type of the
remote batteries that you install.
b. Connect the other end of the battery cable to the battery cable connector on
the battery.
c. Lower and press down on the retention clip until it snaps in place to hold the
battery firmly in place.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation.”
Completing the installation
To complete the installation, complete the following steps:
1. If you removed the air baffle, reinstall it (see “Replacing the air baffle” on page
102).
2. If you removed the server cover, replace it (see “Replacing the cover” on page
102).
3. Install the server in the rack cabinet (see the Rack Installation Instructions that
come with the server for instructions).
4. Reconnect the cables and power cords (see “Connecting the cables” on page
103).
5. Update the server configuration (see “Updating the server configuration” on
page 104).
6. Slide the server back into the rack, if necessary.
7. Start the server. Confirm that it starts correctly and recognizes the newly
installed devices, and make sure that no error LEDs are lit.
8. (IBM Business Partners only) Complete the additional steps in “Instructions for
IBM Business Partners” on page 31.
Chapter 2. Installing optional devices
101