≥
18 kg (39.7 lb)
≥
32 kg (70.5 lb)
≥
55 kg (121.2 lb)
1. Prepare the site to meet all area, environmental, power, and site requirements.
For more information, see “Specifications” on page 18.
2. Move the storage expansion enclosure to the site.
Statement
4:
CAUTION:
Use
safe
practices
when
lifting.
3. Remove the storage expansion enclosure from its shipping container and check
the contents (see “Inventory checklist” on page 3). If any items are missing,
contact your IBM reseller before proceeding.
4. Verify that you have the following software:
v
The correct version of the IBM DS Storage Manager software. See “EXP810
hardware and software compatibility” on page 15.
v
DS4000 controller firmware that ships with the storage expansion enclosure.
You use this software to configure the storage subsystems.
Note:
Different DS4000 models may have different firmware versions.
5. Read
Storage
System
Product
Release
Notes
for any updated information about
hardware, software, or firmware products.
6. Continue with “Preparing the site.”
Tools
and
hardware
required
Gather the tools and equipment you will need for installation. These might include:
v
The rack power jumper cords that are shipped with the storage expansion
enclosure
v
Number 2 Phillips screwdriver
v
5/16 (8 mm) hex nut driver
v
Antistatic protection (such as a grounding wrist strap)
v
Fibre channel (FC) and Ethernet interface cables and cable straps
v
SFP modules
v
Rack-mounting hardware that ships with the storage expansion enclosure
Preparing
the
site
This section lists the floor space requirements and weight information for the
storage expansion enclosure. For information on interface cables and connections,
see Chapter 3, “Cabling the EXP810,” on page 41.
Chapter 2. Installing the EXP810
31
Summary of Contents for DS4000 EXP810
Page 2: ......
Page 67: ...ds470067 Figure 20 Installing a bezel Chapter 2 Installing the EXP810 39...
Page 229: ......
Page 230: ...Printed in USA GC26 7798 09...
