ds470067
Figure
49.
Removing
and
replacing
a
bezel
Replacing
a
filter
and
filter
retainer
Note:
Inspect the filter as needed. Replace the filter every three months or sooner,
depending on your environment.
Complete the following steps to replace a filter and filter retainer:
1. Remove the bezel by grasping the sides of the bezel and pulling it slowly
toward you, as shown in Figure 49.
2. Place the bezel face down on a level surface.
3. Remove the filter retainer and filter from the bezel by pressing the blue tabs
toward the edge of the bezel.
4. Flip the filter retainer over and remove the filter.
5. Remove the new filter from the packaging materials and carefully place it in the
filter retainer.
Note:
Make sure the filter is fitted under all the holding tabs on the filter
retainer frame.
6. Flip the filter retainer over, line it up with the bezel opening and slightly push the
retainer into place.
7. Grasp the sides of the bezel and snap it onto the EXP810 chassis, as shown in
Figure 49.
Chapter 5. Installing and replacing components
91
Summary of Contents for DS4000 EXP810
Page 2: ......
Page 67: ...ds470067 Figure 20 Installing a bezel Chapter 2 Installing the EXP810 39...
Page 229: ......
Page 230: ...Printed in USA GC26 7798 09...
