About
this
document
This document provides instructions for installing and customizing the configuration
of your IBM
®
System Storage DS4000 EXP810 storage expansion enclosure. It also
provides maintenance procedures and troubleshooting information.
Who
should
read
this
document
This document is intended for system operators and service technicians who have
extensive knowledge of fibre channel and network technology.
How
this
document
is
organized
Chapter 1, “Introduction,” on page 1 describes the IBM System Storage EXP810
storage expansion enclosure. This chapter includes an inventory checklist and an
overview of the storage expansion enclosure features, operating specifications, and
components.
Chapter 2, “Installing the EXP810,” on page 29 contains information on how to
install the EXP810.
Chapter 3, “Cabling the EXP810,” on page 41 contains information on how to cable
the EXP810.
Chapter 4, “Operating the EXP810,” on page 67 contains information on how to
power on and off the storage expansion enclosure, recover from an overheated
power supply and fan unit, troubleshoot the storage expansion enclosure, and
interpret LEDs.
Chapter 5, “Installing and replacing components,” on page 87 contains step-by-step
instructions about how to install or remove customer replaceable units (CRUs), such
as hard disk drives, power supply and fan units, dc power supply and fan units,
bezel, filter and filter retainer, environmental services modules (ESMs), midplane,
and SFP modules.
Chapter 6, “Hardware maintenance,” on page 125 describes problems and
symptoms that are specific to your storage expansion enclosure. It also provides a
parts list for the EXP810.
Appendix A, “Upgrading the DS4000 controller firmware,” on page 135 contains
instructions for how to upgrade the existing EXP810 ESM firmware.
Appendix B, “Records,” on page 147 provides a table that you can use to record
and update important information about your EXP810, including serial number and
device records. Whenever you add options to your EXP810, be sure to update the
information in this table.
Appendix C, “Rack mounting template,” on page 151 provides the rack mounting
templates for installation of the EXP810. If you want to tear out the templates from
the document for use during installation, use these copies of the templates.
Appendix D, “Power cords,” on page 155 lists power cord information for the
EXP810.
© Copyright IBM Corp. 2006, 2009
xvii
Summary of Contents for DS4000 EXP810
Page 2: ......
Page 67: ...ds470067 Figure 20 Installing a bezel Chapter 2 Installing the EXP810 39...
Page 229: ......
Page 230: ...Printed in USA GC26 7798 09...
