IBM 6400-i05, Setup Manual

Page: 104 / 370

104
Chapter 4
Main Menu
Main Menu
Figure 66. 6400-I Series Main Menu Configuration
Printer
Control
page 106
Configuration
Management
page 113
5250
Interface
(10)
page 139
Interface Selection
Display Language
Alarm Control
Print Direction
Hex Print Mode
Power On State
Paper Jam Detection
Forms Speed
Set Platen at Bottom
of Form
Shuttle Timeout
Energy Saver Timer
OCR Font Density
Eject/Restore
PTR Setup Option
File System
Power Stacker
(6)
Auto Elevator
(6)
Print Line Select
(11)
Single Bank Select
(11)
Recall Custom Set
Save Current Values
Delete Custom Set
Change Power On Set
Protect Custom Sets
Print Custom Set Values
Name Custom Sets
Reset Custom Set Names Print Language
Print Character Table
Active Print Language
Hex Transparent Control
Undefined Character
Reporting
Undefined Character
Substitution
Print Text Direction
Override Host
Format Control
Maximum Print Width
Twinax
Interface
(1)
page 117
Print Language
Print Character Table
(7)
Active Print Language
Printer Emulation
Printer Address
World Trade
Cancel Buffers
Early Print Complete
(2)
Hex Transparent Control
Undefined Character
Reporting
Undefined Character
Substitution
Load Alternate
Character Option
LAC Approximation
Print Text Direction
Override Host
Format Control
Maximum Printable
Width
Hex Print Mode
C/T Hotport
(8)
Coax
Interface
(1)
page 126
Print Language
Print Character Table
Active Print Language
PA1
PA2
Buffer Reprint
Printer Emulation
(9)
Early Print Complete
SCS Buffer Control
Cancel Buffers
Hex Transparent Control
Mono/Dual Case
Undefined Character
Substitution
Print Text Direction
Image Buffer Size
Intervention Required
Compatibility Options
Translate Table
Override Host
Format Control
Maximum Printable
Width
C/T Hotport
(8)
Hex Print Mode
NOTE:
(1)
The Twinax and Coax interface menus only appear in the menus if the IBM Coax/
Twinax feature is installed.
(2)
The Early Print Complete option appears in the Twinax menu only if the IPDS feature is
installed.
(3)
IPDS, Code V Emulation, and IGP Emulation options appear in the menus only if these
features are installed. Menus are shown in Appendix D.
(4)
Ethernet information only appears when the ethernet feature is installed.
(5)
Ether the Ethernet Interface menu or the Parallel Interface menu will display. They
cannot display at the same time.
(6)
If installed.
(7)
Not if 4234-12 is running IPDS code.
(8)
Only if Autoswitching is enabled.
(9)
Only if Coax Emulation is enabled.
(10)
The 5250 and 3270 Interface menu only appear in the menus if the TN5250/3270
feature is installed.
(11)
6400-i20 and -i24 models only.