IBM 6400-i05, Setup Manual

Page: 280 / 370

280
Chapter 6
Fault Messages
046 EC STOPPED AT
STATE
<state>
No Controller self–test and
initialization sequence
was halted at <state>,
where <state> is one of
10 numerically coded
messages. Contact your IBM service
representative.
056 HAMMER COIL OPEN No Electrical malfunction of
one or more hammer
coils. (You can continue to print
with degraded print
quality.) Contact your IBM
service representative.
057 CLOSE PLATEN Yes Forms thickness lever is
raised to the open
position. Lower the forms thickness
lever.
058 SHUTTLE JAM
SEE SETUP GUIDE
No No shuttle movement or
the shuttle is moving at
the wrong speed. Make sure the ribbon is not
twisted and the forms
thickness lever is set
correctly. If the fault
reoccurs, contact your IBM
service representative.
059 CANCEL PRINT
ACTIVE N/A Non–error status
message. No action necessary.
060 PRINTER HOT No Controller board sensors
report high temperatures
on the board. Contact your IBM service
representative.
062 EXHAUST FAN FAULT Yes Sensors cannot detect
current in fan circuit. Power off the printer.
Check for obstruction of
vents and fan airway;
remove any obstructions.
Check for items beneath
the printer blocking cabinet
vents. Power back on the
printer. If this message
reoccurs, contact your IBM
service representative.
NOTE: This message
should not appear on a
Pedestal model. If this
message does appear,
contact your IBM Service
Representative.
Table 12: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution