IBM 3746-900, Installation And Maintenance Manual

Page: 39 / 264

6. Install the 8228 in a safe place near the Service Processor. If you received a
controller expansion, the 8228 is installed on the rear side of the controller
expansion using two screws (PN 1621232) and two captive nuts (PN 58G5766)
see Figure 1-15 on page 1-19. Using label
A
(PN 0782966), identify the
8228 as Service Processor Access Unit.
A
Figure 1-15. Installing the 8228 (Controller Expansion Rear Side)
7. Connect the 8228 to the Service Processor as follows:
Note: If you have a controller expansion, see Figure 1-17 on page 1-20, if
not, see Figure 1-16 on page 1-20.
a. Plug connector
1
of cable
A
to the Service Processor.
b. Using a sticker, identify the connector
2
as the "Service Processor cable."
c. Plug connector
2
to any plug of the 8228 from 1 to 8.
Chapter 1. Installing and Setting Up Your Service Processor
1-19