IBM 3746-900, Installation And Maintenance Manual

Page: 86 / 264

MAP (continued)
Table 3-1 (Page 5 of 12). POST Errors
Symptom / Error FRU to replace / Action to take
1106
Serial option cannot be turned off.
1. Run Enhanced Diagnostics.
2. System Board
1107 1. Serial Device Cable
2. System Board
1110
Register test failed.
1. Run Enhanced Diagnostics.
2. System Board
1116
Interrupt error.
Run Enhanced Diagnostics.
1117
Failed baud rate test.
Run Enhanced Diagnostics.
1162
Serial port configuration error.
1. Run Configuration.
2. Serial Adapter (if installed)
3. System Board
11 XX
Not listed previously
System Board
1201 1. System Board
2. Any Serial Device
1202 , 1206 , 1208 , 1209 , 12 XX 1. Dual Async Adapter/A
2. System Board
3. Any Serial Device
1207 1. Communications Cable
2. Dual Async Adapter/A
13 XX Game Adapter
1402
Printer not ready.
Information only
1403
No-paper error, or interrupt failure.
Information only
1404
System board timeout failure.
Run Enhanced Diagnostics.
1405
Parallel adapter error.
Run Enhanced Diagnostics.
1406
Presence test error.
Run Enhanced Diagnostics.
14 XX
Not listed above.
Check printer before replacing system
board.
1. See “Printer” on page 3-19.
2. System Board
15 XX SDLC Adapter
1692
Boot sequence error.
Run FDISK to ensure at least one
active partition is set active.
16 XX 36/38 Workstation Adapter
1762
Hard disk drive configuration error.
Run Configuration/Setup Utility (see
“Service Processor Configuration /
Setup Utility” on page H-8).
3-6
3745-XXA 3-6 3746-9X0: 6578 SPIM