IBM 3746-900, Installation And Maintenance Manual

Page: 153 / 264

| Note: If you are installing a Wake on LAN-supported network adapter, attach
| the Wake on LAN cable that came with the adapter to the Wake on LAN
| connector on the system board. If you also want to take advantage of the Alert
| on LAN feature of the computer, you must install the network adapter in PCI
| slot 1.
9. Install the retainer and secure it with the screw previously removed.
10. Plug the cable previously removed to the rear of the adapter card.
11. Reinstall the Service Processor top cover.
12. Go to “After FRU Exchange.”
Other FRUs Exchange
1. Locate the FRU to exchange.
2. With the help of figures given in “Computer Exploded View” on page H-1
remove the FRU.
3. Unpack and install the new FRU.
4. Reinstall the Service Processor top cover.
5. Go to “After FRU Exchange.”
After FRU Exchange
1. For setting up the Service Processor after FRU exchange use the following
steps:
a. If the Service Processor was installed in a controller expansion, continue
with step 1b. Otherwise, go to step 1c.
b. Slide the Service Processor into the controller expansion.
c. At the rear of the Service Processor reconnect all the cable previously
removed.
2. Use Table 5-2 to find the procedure you need to follow after exchanging an
FRU.
Table 5-2. FRU Exchange Procedures
Service Processor
FRU to Exchange Action
Battery
Board Go to “After Battery or Board Exchange” on page 5-10.
Hard Disk Drive Go to “After Hard Disk Drive Exchange” on page 5-12.
Token-Ring Adapter Go to “After Token-Ring Adapter Card Exchange” on
page 5-10.
Other FRUs Go to “After Other FRU Exchanges” on page 5-15.
Chapter 5. Service Processor FRUs / Display Exchange
5-9