![background image](http://html1.mh-extra.com/html/ibm/3454-fce/3454-fce_customer-install-manual_3327826009.webp)
© Copyright IBM Corporation 2020. Customer Install Guide, PDU
9
– For racks with AC power, connect all power cords to a properly wired and
grounded electrical outlet. Ensure that the outlet supplies proper voltage and
phase rotation according to the PDU/system rating plate.
Connect any equipment that will be attached to this product to properly wired
outlets.
When possible, use one hand only to connect or disconnect signal cables.
Never turn on any equipment when there is evidence of fire, water, or structural
damage.
Do not attempt to switch on power to the machine until all possible unsafe
conditions are corrected.
Assume that an electrical safety hazard is present. Perform all continuity,
grounding, and power checks specified during the subsystem installation
procedures to ensure that the machine meets safety requirements.
Do not continue with the inspection if any unsafe conditions are present.
Before you open the device covers, unless instructed otherwise in the installation
and configuration procedures: Disconnect the attached AC power cords, turn off
the applicable circuit breakers located in the rack power distribution panel (PDP),
and disconnect any telecommunications systems, networks, and modems.
DANGER:
Connect and disconnect cables as described in the following procedures when
installing, moving, or opening covers on this product or attached devices.
To Disconnect:
1. Turn off everything (unless instructed otherwise).
2. For AC power, remove the power cords from the outlets.
3. For racks with a DC power distribution panel (PDP), turn off the circuit
breakers located in the PDP and remove the power from the Customer's DC
power source.
4. Remove the signal cables from the connectors.
5. Remove all cables from the devices.
To Connect:
1. Turn off everything (unless instructed otherwise).
2. Attach all cables to the devices.
3. Attach the signal cables to the connectors.
4. For AC power, attach the power cords to the outlets.
5.Turn on the devices.
Sharp edges, corners and joints may be present in and around the system. Use care
when handling equipment to avoid cuts, scrapes and pinching. (D005)
Summary of Contents for 3454-FCE
Page 6: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 6 Safety...
Page 52: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 52 Figure 29 EPO Setup...
Page 67: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 67 Regulatory and Compliance...
Page 74: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 74...