pakedge
device&software
inc.
P8 -
Boot Sequence Power Distribution Unit with Remote Power Cycling
Quick Start-
version 1.0
Quick Installation
1.
Power on the P8 and connect it to the Local Area Network (LAN) via the 10/100 Base-T Ethernet
port.
2.
By default, the P8 will begin to power on the outlets beginning with the “Modem” outlet. After 60
seconds, it will power on the “Router” outlet and then continue to power on the remaining outlets.
3.
To access the P8’s web interface, make sure that your computer’s IP address is on the same
subnet as the P8, open up a web browser and enter
192.168.1.210
(P8’s default IP address) in
the address bar.
