![background image](http://html1.mh-extra.com/html/ibm/3454-fce/3454-fce_customer-install-manual_3327826011.webp)
© Copyright IBM Corporation 2020. Customer Install Guide, PDU
11
Do not install a unit in a rack where the internal rack ambient temperatures will
exceed the manufacturer's recommended ambient temperature for all your rack-
mounted devices.
Do not install a unit in a rack where the air flow is compromised. Ensure that air
flow is not blocked or reduced on any side, front, or back of a unit used for air
flow through the unit.
Consideration should be given to the connection of the equipment to the supply
circuit so that overloading of the circuits does not compromise the supply wiring
or overcurrent protection. To provide the correct power connection to a rack,
refer to the rating labels located on the equipment in the rack to determine the
total power requirement of the supply circuit.
(For sliding drawers.)
Do not pull out or install any drawer or feature if the rack
stabilizer brackets are not attached to the rack. Do not pull out more than one
drawer at a time. The rack might become unstable if you pull out more than one
drawer at a time.
(For fixed drawers.)
This drawer is a fixed drawer and must not be moved for
servicing unless specified by the manufacturer. Attempting to move the drawer
partially or completely out of the rack might cause the rack to become unstable or
cause the drawer to fall out of the rack.
CAUTION:
Removing components from the upper positions in the rack cabinet improves rack
stability during relocation. Follow these general guidelines whenever you relocate a
populated rack cabinet within a room or building.
Reduce the weight of the rack cabinet by removing equipment starting at the top
of the rack cabinet. When possible, restore the rack cabinet to the configuration
of the rack cabinet as you received it. If this configuration is not known, you must
observe the following precautions:
– Remove all devices in the 32U position and above.
– Ensure that the heaviest devices are installed in the bottom of the rack cabinet.
– Ensure that there are little-to-no empty U-levels between devices installed in
the rack cabinet below the level, unless the received configuration specifically
allowed it.
Summary of Contents for 3454-FCE
Page 6: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 6 Safety...
Page 52: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 52 Figure 29 EPO Setup...
Page 67: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 67 Regulatory and Compliance...
Page 74: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 74...