© Copyright IBM Corporation 2020. Customer Install Guide, PDU
37
11. Route the power cord from the PDU toward the rack side braces.
Route the power cord along a side brace toward the rear of the rack and secure
the power cord with the cable straps that are provided with the PDU.
12. Route the power cord toward a dedicated power source.
Use the provided cable straps to secure the power cord along the way. If the
power cord must exit the rack to connect to a power source, use the openings in
the rack.
Attention To prevent damage to a power device and other connected devices,
always connect the power device to an authorized power source for that device.
13. Connect the power cord to a properly wired and grounded dedicated power
source. IBM Installers will connect the components in the rack to the power
outlets on the PDU. IBM installers will route all internal signal cables before
powering on the system.
14. If the side covers or doors were removed, reinstall them.
ALL OPEN RACK BAYS REQUIRE FILLERS TO PREVENT HOT AIR FROM
RECIRCULATING TO THE FRONT OF THE RACK AND INTO THE COLD
AIR INLETS.
DO NOT BLOCK ANY INLET OR EXHAUST DUCTS, VENTS OR PORTS
KEEP ALL POWER CORDS, SIGNAL CABLES AND TRANSCEIVERS WITH
THE INSTALLED CHASSIS FOR USE BY IBM INSTALLERS.
DO NOT POWER-ON THE PDUs/SYSTEM. IBM installers will install
signal/power cables and power on the system.
Summary of Contents for 3454-FCE
Page 6: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 6 Safety...
Page 52: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 52 Figure 29 EPO Setup...
Page 67: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 67 Regulatory and Compliance...
Page 74: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 74...