![background image](http://html1.mh-extra.com/html/ibm/3454-fce/3454-fce_customer-install-manual_3327826061.webp)
© Copyright IBM Corporation 2020. Customer Install Guide, PDU
61
Resetting the PDU
The following procedures are required to reset the password or reset the PDU to factory
defaults.
Password reset
If your password is lost and you can’t log into your PDU, the password can be reset with
the following process:
Push reset button three times to go into password reset mode
1 Push the reset button for one second then wait for the yellow LED to blink once
2 Push the reset button again for one second then wait for the yellow LED to
blink once
3 Push the reset button again for one second then for the yellow LED to blink
continuously
You now have 10 seconds to push the reset button for 3 seconds while the yellow LED
is blinking
If the reset button is pushed for 3 seconds, the password will be reset to factory default.
See the
Starting the Web Interface
section for factory password log in instructions.
If nothing is pushed while the yellow light is blinking, the password will not be reset.
Figure 40 - Reset button sequence for password reset
Summary of Contents for 3454-FCE
Page 6: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 6 Safety...
Page 52: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 52 Figure 29 EPO Setup...
Page 67: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 67 Regulatory and Compliance...
Page 74: ...Copyright IBM Corporation 2020 Customer Install Guide PDU 74...