7-25
Throttle 0 zone
It establishes a deadband in the accelerator input curve (see also curve below).
Throttle X point
This parameter changes the characteristic of the accelerator input curve.
Throttle Y point
This parameter changes the characteristic of the accelerator input curve.
Λ
Μ
Ν
SPEED f(Hz)
MAX SPEED
TROTTLE Y
POINT
FREQ. CREEP
VACC
MIN
THROTTLE 0
ZONE
THROTTLE X
POINT
VACC
MAX
V
20B7EL17
VACC MIN and VACC MAX are values programmable by the "Program Vacc" function.
Adjustment #2 bdi
It adjusts the lower level of the battery discharge table.
Adjustment #1 bdi
It adjusts the upper level of the battery discharge table.
Adjustment #03 :
Set an increment of battery charge above actual value. If battery voltage exceed this total value
the software recognize charging, and battery charge percentage increase to correct value also if
battery isn't fully charged.
Main cont. voltage
This parameters adjusts the line contactor coil voltage (PWM output C26).
Aux output voltage
This parameters adjusts the solenoid coil voltage (PWM output C28).
Adjustment #04 :
This parameter determines the motor temperature level at which the "Motor temperature" alarm is
signalled. This parameter must be adjusted only if the "Set temperature" (menu "Set option")
parameter is programmed "Analog".
Speed factor
It adjusts the speed coefficient to have the correct speed indication on the display. This coefficient
has to be regulated depending on truck mechanic characteristics. It results from the following
formula :
Speed factor = 88 * rr * p /
͚
where:
rr = total gearbox ratio
͚
= traction wheel diameter (cm)
P = number of pair poles of the motor
Ξ
Ο
Π
Ρ
Σ
Τ
