HySecurity HSG80F, Programming And Operations Manual

Page: 85 / 138

© 2018 Bi-Parting & Dual Gate Systems MX3636-01 Rev. D 71
1. As shown in the wire diagram on page 70, connect a shielded communications cable to the DUAL
GATE inputs in each operator. The inputs are located near the base of the Smart Touch Controller. Be
sure to connect the wires in pairs to the same terminal ports (A-A, B-B, COM-COM) on both operators.
2. Attach a ring terminal to the shield wire and connect it to the Smart Touch Controller’s convenient
ground screw.
NOTE: Connect the ground shield wire to only one operator,
not both. Use only 18-20 gauge twisted and shielded triple wire.
Sequenced gates are very similar to dual gates (interlocked pair) in their Power,
Software, and Accessory Requirements. To review the installation site requirements,
refer to
Bi-Parting & Dual Gate Systems on page 67.
SG 0
SEQUENTIAL GATE
Status Display
User Menu Installer Menu
Sequence Gate
Status Display
SG 0
Press Menu twice at
the gate status display.
To access the Installer Menu,
press and hold Reset & Open,
and then release them.
Press Next until “SG”
characters appear.
Press Select so “SG” characters blink.
Press Next to change the display:
SG 1 = Sequenced Gate #1 configuration
SG 2 = Sequenced Gate #2 configuration
SG 3 = Sequenced Gate #3 configuration (only used with HydraSupply XL)
SG 4 = Sequenced Gate #4 configuration (only used with HydraSupply XL)
NOTE
:
Set gate operators on the site to the uniquely paired number. Refer to the site designs
on the following pages.
Press Select again and a gate status
display appears indicating the sequenced
gate entry had been accepted.