HYBREX G1 8-24, Manual

Page: 163 / 200

163
Station Security Code / Station
Description
This feature allows a station user to restrict his telephone by dialing a security code. This makes the
station unusable for outside dialing. Outside lines can still be accessed, but unless the number dialed
appears as an exception on Mode 59, the CO line will be disconnected as soon as three digits are dialed
on the CO line.
Conditions
Security codes must be three digits in length.
Intercom calls can still be placed and received.
Incoming telephone calls can still be received.
Station Security Code does not apply to single line telephone sets.
Telephone numbers entered on Mode 62, Common Permitted Codes are allowed from locked telephones.
Programming
Mode 07 may be programmed with a Station Lock Key- FN:14. Mode 07 may also be programmed with a
One Call Only Unlock Key- FN:16.
Note: The status of a station can be controlled from Mode 40-[station]-07, Lock/Unlock by Security
Code. However, if a station is initially programmed to be locked and has never had a security
code programmed, it can only be unlocked by a system operator or by changing the information
in 24-[STN]-07.
Operation
To Lock Your Station
:
1. Press [PGM] , [LOCK] if your station has a Lock button,
OR
Press
[PGM]
,
[9]
2. LCD (if equipped ) will display: Security Code
3. Enter a three digit code.
4. Press
[SAVE] . Press [SPK]. Your station is now locked. The LCD will display in the upper right
hand corner:
Lock On
Note
: It is important that you remember the code used to lock your telephone. You must use it to unlock
your telephone. If you forget, the telephone can only be unlocked by the attendant or through
system programming.
To Unlock Your Station
:
You may unlock your station by repeating the same steps that lock it.
Your display will show:
Lock Off
To Temporarily Unlock Your Station
:
1. Press [PGM] , [#] or [Unlock One Call] key .
2. LCD (if equipped ) will display: Security Code
3. Enter the three digit code used to lock the telephone set.
4. If the code matches the code used to lock the set, you will be connected to an outside line. You
may place a call.
5.
As soon as you disconnect from the outside line, the telephone set will revert back to its original
locked status.
Note:
When locking a station, any three digit code may be used. When unlocking a station, the code
must be the same as the code that was used when the station was previously locked.