OPERATION
46
■
Slide out the snap slide end cap from
the bottom weight.
■
Slide the panel out of the bottom weight.
IMPORTANT:
Note the folded flap at the
bottom of the panel and how it is folded.
■
Unfold the fabric and carefully remove
the plastic strip from the panel. Save it
for later use.
■
Holding the bottom end of the panel flat,
mark the distance (previously recorded)
at several locations across the bottom of
the panel. Using a straight-edge, draw a
line connecting these marks.
■
Using a sharp pair of scissors, carefully cut straight across each panel along the line to
remove the desired length from each panel.
■
Replace the previously removed plastic adhesive strip along the bottom of the panel,
aligning the strip with the bottom edge of the panel. Push on the plastic adhesive strip so it
adheres to the panel.
■
Carefully crease the panel along the upper edge of the strip.
IMPORTANT:
Make sure there are no ripples in the fabric panel.
■
Holding the folded panel and plastic
strip, carefully insert the panel into
the bottom weight until it is fully
seated within the bottom weight.
CAUTION:
Be careful NOT to pull on
the fabric, as it can cause permanent
distortion or damage.
■
Re-install the snap slide end cap.
Summary of Contents for Skyline PowerView
Page 1: ...Installation Operation Care Skyline Gliding Window Panels PowerView Motorization...
Page 58: ...Notes...
Page 59: ......
