HunterDouglas Skyline PowerView, Installation Operation Care

Page: 16 / 60

INSTALLATION
14
Fabric Valance without Returns
■
If the fabric cover is not already installed:
➤
Clip the narrow edge of the fabric over
the top of the dust cover and into the
slot as shown.
➤
Pull the wide edge of the fabric over
the bottom of the dust cover and clip
it into the ridge on the bottom edge of
the dust cover.
■
Lay the dust cover upside down on a clean working surface.
■
Place the mounting clips on the dust cover:
➤
The release tabs must be facing away from the valance. (They face toward the wall.)
➤
The end mounting clips must be 2" to 4" from the end of the dust cover.
➤
Intermediate mounting clips must be 18" to 24" from each other or the end
mounting clips.
➤
The center line of the holes in the mounting clips must be 1½" from the valance.
Dust Cover
Slot
Ridge
Release Tab
1
1 /
2
"
Dust Cover
Intermediate
Valance Clips
Valance
2"-4" 18"-24" 2"-4" 18"-24" 18"-24"
Jamb Jamb