INSTALLATION
38
■
Locate the panel marked “REAR PANEL — INSTALL FIRST.” This is the first panel to install.
■
Locate the temporary plastic fabric hanger installed in the headrail. You will install the first
panel into the same carriers. Remember the carriers into which the hanger is installed,
remove the temporary hanger. Twist it gently to remove.
■
With the front side of the rear panel facing you, insert the LEFT side of the fabric hanger
into the carrier in the FRONT channel (see No. 1).
■
If you have 17" panels, slide the center guide into the center channel in the headrail
(see No. 2).
■
Gently twist the fabric hanger inward and insert the RIGHT side of the fabric hanger into the
carrier in the REAR channel (see No. 3).
IMPORTANT:
After you have installed the first panel, verify that the flush end cap on the
bottom weight is on the LEFT side. The flat side of the bottom weight should face the
window.
■
Continue installing panels, FRONT channel first. The last panel you install will be marked
“FRONT PANEL — INSTALL LAST.”
IMPORTANT:
This panel has two flush end caps on the bottom weight.
■
Test traverse (use the button on the receiver).
Right Stack/Left Facing
Front Channel
Rear Channel
Front Carrier
Center Channel
Center
Guide
Rear Carrier
1.
Insert the left side of
the fabric hanger into
the front carrier.
3.
Insert the right side of
the fabric hanger into
the rear carrier.
2.
Put the center guide into
the center channel
(17" panels only).
Flush End Cap
Window
Room
Headrail (Top View)
Right Stack/Left Facing
Bottom Weight
Summary of Contents for Skyline PowerView
Page 1: ...Installation Operation Care Skyline Gliding Window Panels PowerView Motorization...
Page 58: ...Notes...
Page 59: ......
