INSTALLATION
23
■
Bow the clip and snap it into the track on
the lower edge of the cassette.
■
Clip the fabric-wrapped large cassette splice
cover over the fabric seam, clipping the
bottom on first, then snapping the top of
the splice cover into place.
IMPORTANT:
The splice cover will be
used any time you need to cover a fabric
seam. This will be necessary when the
cassette is spliced. It will also be used
when the fabric is seamed. The fabric
seaming is sometimes necessary to obtain
the full width of the cassette. In this case,
the splice cover will be installed by the fabricator.
Mount the Headrail
■
Refer to the appropriate section below for your order type:
➤
One Piece Headrail — below
➤
Spliced Headrail Mounting without Fabric-Wrapped Large Cassette — page 24
➤
Spliced Headrails with a Fabric-Wrapped Large Cassette — page 24
One Piece Headrail
IMPORTANT:
The headrail must be mounted level for the panels to operate correctly. Use your
level to check that the mounting clips are aligned and level.
■
Orient the headrail so that the control side
is located on the correct side.
■
Center the headrail underneath the
mounting clips.
■
Starting with the center, tilt the headrail
and engage it under the lip of the
mounting clips.
■
Rotate the headrail upward and snap it
into place.
■
Make sure the headrail is secure.
1
2
Room
Hook Lip
Mounting
Clip
Headrail
Snap into Place
Summary of Contents for Skyline PowerView
Page 1: ...Installation Operation Care Skyline Gliding Window Panels PowerView Motorization...
Page 58: ...Notes...
Page 59: ......
