Human Elisys Quattro, User Manual

Page: 76 / 88

7-2 ELISYS QUATTRO User Manual HUMAN
Error Messages
Colorimeter EEPROM
error Error during EEPROM reading or
writing. Call service.
Colorimeter filter %1
error Error at filter no. %1. The gain factor
for the respective filter cannot be
identified. Filter is faulty or wrong fil-
ter has been installed. Call service to check the installed filter
and to replace it, if necessary.
Colorimeter filter
motor home error The system does not recognise the
current position of the filter motor.
Move to the home position. Select the menu item Utilities |
Selftest to initialise the system
again.
Colorimeter filter
motor movement
error The system does not recognise the
current position of the filter motor.
Move to the home position. Select the menu item Utilities |
Selftest to initialise the system
again.
Colorimeter lamp
error Halogen lamp of photometer is
faulty. Replace the halogen lamp.
Colorimeter optic
channel %1 error Error in one of the 9 optical chan-
nels. Upper or lower optic block is
dirty or faulty. The optical blocks have to be cleaned
by service personnel. Call service.
Colorimeter plate
motor home error The system does not recognise the
current position of the plate motor in
the measuring area. The plate motor
has to be moved to the home posi-
tion. Select the menu item Utilities |
Selftest to initialise the system
again.
Colorimeter plate
motor movement
error Error of motor when moving the
plate to the measurement area. Select the menu item Utilities |
Selftest to initialise the system
again. If the error persists, call service.
Colorimeter voltage
reference error Error in reference voltage of the pho-
tometer. Call service.
COMGEN error '%1' RS232 connection faulty. Check correct connection between PC
and analyzer. Start PC and analyzer
again.
COMGEN target over-
flow error - Call service.
COP serial port test
error The components are connected via
serial interfaces to the control board.
Error in serial interfaces. Call service.
ERROR: Argument
error in '%1' Component cannot be actuated.
Error in component %1. Call service.
Error scheduling
plate '...' Error in assay or missing resources.
This error message is displayed in
the worklist for the respective plate,
after the active worklist has been
verified. The worklist or the assay has to be
changed accordingly.
Incubator heater %1
error Defect in heater foil no. %1. Call service.
Incubator sensor %1
error Defect of incubator sensor no. %1. Call service.
Error: Cause: Action: