Hudson 1948 - 1952, Service Manual

Page: 103 / 333

COPYRIGHT 1950 BY CARTER CARBURETOR CORPORATION. ALL RIGHTS RESERVED .
FUEL SYSTEM & EXHAUST 4 - 19
6. Remove a 11 parts from the carburetor body, except
nozzles and other pressed in parts, Figure 58.
FIGURE 58
7. Remove all parts from the body flange assembly, Figure
59.
FIGURE 59
NOTE: Wash all parts in a good carburetor cleaning solution,
except the thermostatic coil and housing assembly and the
pump plunger.
CAUTION: DO NOT SOAK THE BOWL COVER
ASSEMBLY FOR MORE THAN ONE-HALF HOUR.
NOTE: Carefully note slots in choke piston cylinder.
If they are carbonized, remove the welsh plug by
piercing center with a small pointed instrument and
pry outward. Be careful not to damage the casting.
Blow out all passages with compressed air and scrape
carbon from bores of flange. Replace all worn or damaged
parts and all gaskets.
After cleaning carburetor parts, group as follows:
1. Group all parts controlling gasoline level, Figure 60.
FIGURE 60
2. Group all parts controlling the idle operation, Figure 61.
FIGURE 61
3. Group all parts controlling the high speed operation,
Figure 62.
FIGURE 62