Command Manual – MSTP
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 MSTP Configuration Commands
Huawei Technologies Proprietary
1-20
Note:
z
The digest snooping feature is needed only when your S3900 series switch is
connected to partner's proprietary protocol-adopted switches.
z
To enable the digest snooping feature successfully, you must first enable it on all the
ports of your S3900 series switch that are connected to partner's proprietary
protocol-adopted switches and then enable it globally.
z
To enable the digest snooping feature, the interconnected switches must be
configured with exactly the same MST region-related configuration.
z
The digest snooping feature must be enabled on all the ports of your S3900 series
switch that are connected to partners' proprietary protocol-adopted switches in the
same MST region.
z
With the digest snooping feature enabled, the VLAN-to-MSTI mapping cannot be
modified.
z
The digest snooping feature is not applicable to MST region edge ports.
Example
# Enable the digest snooping feature on Ethernet1/0/1 port in system view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] stp interface Ethernet 1/0/1 config-digest-snooping
1.1.19 stp interface cost
Syntax
stp interface interface-list
[
instance instance-id
]
cost cost
undo stp interface interface-list
[
instance instance-id
]
cost
View
System view
Parameter
interface-list
: Ethernet port list. You can specify multiple Ethernet ports by providing this
argument in the form of
interface-list =
{
interface-type interface-number
[
to
interface-type interface-number
] } &<1-10>, where &<1-10> means that you can
provide up to 10 port indexes/port index ranges for this argument.
instance-id
: Spanning tree instance ID ranging from 0 to 16. A value of 0 specifies the
CIST.
cost
: Port path cost to be set. This argument ranges from 1 to 200,000,000.