26
Apply an upward force on the upper ejector
lever and a downward force on the lower
ejector lever, and draw the filler panel out.
5
Installing Boards
Installing Cross-Connect Boards or Service Boards in Cross-Connect Board Slots
b
Raise the ejector levers of the board with both hands. Push the
board gently along the top and bottom guides. Use both thumbs
to press ejector levers on the board until the board engages with
the backplane socket. Confirm that the plug on the board is
aligned against the socket on the backplane. Press the upper
and lower ejector levers to grip the subrack.
Installing a service board into a cross-connect board slot
in a T16 subrack
Tighten the bolts.
Installing the cross-connect
board
NOTE
Hold the handle to push the special filler
panel into the slot along the guide rail, as
shown in the figure below.
A cross-connect board slot is too large to hold a service board. Therefore, a special filler panel is therefore
developed for the cross-connect board slot. A service board can be installed in a cross-connect board slot after it is
installed on this special filler panel.
NOTE
The cross-connect board is installed in a similar way in all types
of subracks. The following uses installing a cross-connect board
in a T32 subrack as an example.
0.39
±
0.04 N.M
M3
2# screwdriver
