User Manual
U-SYS IAD108 Integrated Access Device
Chapter 4 Configuring Data
4-8
example: “>” indicates that the command mode is user mode, while #
indicates privilege mode. In the global config mode, you can use the
command
hostname
to configure the fixed character string. By
default, the fixed character string of the system is “IAD2000”.
Example: Modify the default host name of the system into
“IAD108”.
IAD2000(config)#
hostname IAD108
To change command line prompt is ok
IAD108(config)#
This command is executed successfully, and the host name has
been changed into “IAD108”.
4.2.1 Command Modes
IAD108 has the following command modes: User mode,
privilege mode, global config mode, advanced mode, debug mode,
and LAN switch mode. During data configuration, commands are
frequently used to switch over the command modes and save the
data.
Note:
It is unusual to use the commands in advance mode and debug mode to configure
and maintain the device, therefore, only the features and usage of some usually
used commands are introduced in this manual.
The commands used in advance mode and debug mode can be found in Appendix
A.
