User Manual
U-SYS IAD108 Integrated Access Device
Chapter 4 Configuring Data
4-36
mgcip |
mgcport
mgcport |
mgc-domain-name
mgc-domain-name
}
The configuration result can be check by using command
show
mg attribute
in user mode.
Caution:
IP address of the IAD108 should be configured before configuring MG attribute. To
do this, carry out command
ip address
ip-address net-mask
def-gateway
in global
config mode. If the IP address is configured later than the MG attribute, the IAD108
will register to the MGC again.
For the data that should be kept consistent on the IAD108 and MGC, refer to Table
4-2.
II.
Parameter descriptions
The parameters of the commands used to configure MG
attribute are listed in Table 4-12.
