3.
Repeat steps 1 and 2 for the remaining rail.
Converting the rails
The cabinet rail kit supplied with the drive enclosure comes configured for square-hole cabinets. If
you need to convert the rails for a round-hole cabinet, perform the following steps:
IMPORTANT:
Do not remove the pins from the ends of the rails unless you are converting the rails for use in
round-hole cabinets. These load-bearing pins are designed to fit through the holes without being
removed.
1.
Locate the bag of eight round-hole pins that is included in the cabinet rail kit.
2.
Use a No. 2 Phillips screwdriver to remove the standard pins from the front and back of the left
and right rails (four on each rail).
3.
Attach the round-hole pins into the eight holes on the rails where the standard pins were removed.
Attach the rails
NOTE:
The designation of left and right rail is made when looking at the front of the rack. The rails are
marked by an R (right) and L (left) stamped on the metal.
Consider the following when installing the rails:
•
Installing the rails does not require any tools for assembly.
•
HP recommends you install all the rail kits before installing any other components.
•
Ensure the rail is level before installing any other components.
WARNING!
Before you begin, make sure that the cabinet is sufficiently stable. If provided, lower the cabinet leveler
feet and make sure any required stabilizers are installed. If provided, extend the anti-tip device.
Failure to extend the anti-tip device could result in personal injury or damage if the cabinet tips over.
HP StorageWorks 4400 Enterprise Virtual Array installation guide
27
Summary of Contents for StorageWorks 4400
