First-Time Configuration
Setup Part 5: Final Steps
1. When prompted, decide whether to restart Setup or continue:
Would you like to run from top again? [y/n]
Enter
y
to restart the Setup utility from the beginning, or
n
to continue. If you select
y,
the Setup Utility restarts. The changes you made are shown as pending configuration
which you can accept or update.
2. When prompted, decide whether you wish to review the configuration changes:
Review the changes made? [y/n]
Enter
y
to review the changes made during this session of the Setup utility. Enter
n
to
continue without reviewing the changes. HP recommends that you review the changes.
3. Next, decide whether to apply the changes at the prompt:
Apply the changes? [y/n]
Enter
y
to apply the changes, or
n
to continue without applying. Changes are normally
applied.
4. At the prompt, decide whether to make the changes permanent:
Save changes to flash? [y/n]
Enter
y
to save the changes to flash. Enter
n
to continue without saving the changes.
Changes are normally saved at this point.
5. If you do not apply or save the changes, the system prompts whether to abort them:
Abort all changes? [y/n]
Enter
y
to discard the changes. Enter
n
to return to the
Apply the changes?
prompt.
NOTE:
After initial configuration is complete, it is recommended that you change the default
passwords as shown in the “Setting Passwords” section.
Optional Setup for Simple Network Management Protocol Support
NOTE:
This step is optional. Perform this procedure only if you are planning on using Simple Network
Management Protocol (SNMP)-based tools.
1. Use the following command to enable SNMP:
>> #
/cfg/sys/snmp disable|read only|read/write
2. Set SNMP read or write community string. By default, they are public and private
respectively:
>> #
/cfg/snmp/rcomm|wcomm
3-10
HP ProLiant BL p-Class GbE2 Interconnect Switch Command Reference Guide
HP CONFIDENTIAL
Codename: Strawberry Part Number: 331404-001 Last Saved On: 7/17/03 12:50 PM
